Cell disruptor / Mini Homogenizer

AUD 2,500.00    Excl.GST
  • Product Code: CD-901
  • Availability: Out Of Stock

This instrument was upgraded & modified by GMES, responsible for after-sales maintenance


Mini Homogenizer is a mini-sized homogenizer ideal for the disruption of samples in 2.0ml screw cap microtubes. 


The unique design of the tube holder allows for six tubes to be inserted per mixing cycle.  


CAUTION: The machine is intended for use with 2ml screw cap tubes.


To avoid the risk of personal injury, always follow the loading instructions below.  Failure to use this instrument as described below will void the warranty.

 

we also have 0.1mm/0.3mm/0.5mm/1mm/3mm  zirconia grinding balls for sale(500g per bottle)


I. Product Specifications:   

    Speed / Control:                                           User settable 2800 to 4000 rpm

    Timer:                                                   3 second to 3 minutes

    Max. Capacity:                                                   6 x 2.0ml  / 6 x 5.0ml  /   

    Large centrifuge tube fasteners upgradeable:     2 x 15.0ml / 1 x 50.0ml

    Dimensions (wxdxh):                                                230x240x180mm,

    Weight:                                                                        6.1kg.

    Electrical:                                                                    US 110VAC, 60Hz,    EU/AU 230VAC, 50Hz

    Operating environment:                                          4˚ C to 65˚ C;   (Airflow cooling module Upgradeable)

    Warranty:                                                                    2 years


II. Product Set-Up:

CAUTION: For safe transport during shipping, the motor has been secured with two transport screws located on the base of the instrument. Before operating the mixer, Remove The 2 RED Wing Nut Screws from the base of the instrument.

Place the mixer on a clean, flat, stable surface.  Ensure that the power switch is in the OFF             position and plug the mixer into a properly grounded outlet.  Open the lid and insert your 2.0ml

Screwcap tubes in the tube holder by placing the conical point through the hole and forcing the tube into place. CAUTION: Always follow proper loading and balancing instructions.


III. Product Operation:

Using the up and down arrows, select the desired speed and time.  Ensure that tubes are fully inserted within the groove of the tube holder and close the lid.  Once the lid has been closed, press the “Start/Stop” key to begin the mixing cycle.  

At the end of the desired run time, open the lid and remove your sample tubes.


IV. Care and Maintenance:

No routine maintenance is required other than to keep the unit clean and to wipe up and spillage that may occur.